For a while, the issue of the blinking light after the TP-Link Extender Setup can irritate you. Even after you complete the TP-Link Extender login process and adjust its settings, the problem may persist. Because the LED lights indicate the condition and operation of the extender, it’s crucial to understand what they mean. You can use the reset option if the power LED continues to flash.
What is the benefit of a TP-Link extender reset?
Is your TP-Link extender not operating properly? This isn’t a problem because the extender reset may be able to fix it, as well as some of the other difficulties listed below:
- The extender isn’t functioning correctly.
- Issues with logging.
- The TP-Link extender’s flashing light.
- Issues with device compatibility.
- Wireless gadget malfunctions.
If you’re determined to reset your extender, keep the following guidelines in mind.
- Before the extender restarts, you can turn it on. Avoid using an extender cord to connect your extender. Use of worn-out cables should be avoided.
- Make a list of the default IP address, password, and domain name.
The steps to make a factory reset are as follows:
When you can’t remember the admin password for your wifi range extender, you’ll need to perform a factory reset. You can do a hard reset or a router reset in a more straightforward manner. A factory reset will get your gadget ready for the new software. For this, follow the instructions provided.
- Connect the extender to a power supply. Press the power or ON/OFF button if the power LED does not glow. Wait until the extender’s LEDs have established. Wait! this may take some time.
- Now look for the reset or factory reset button on the extender. It’s easy to find behind the little hole on the side or bottom panel of the extender.
- Press the factory reset button with a paper clip or similar-sized object. Keep pressing the button for up to ten seconds until the power LED blinks.
- Wait until the extender’s LEDs have stabilised. This could take some time.
- The extender has reset, and you may now proceed with the TP-Link Extender Setup.
The TP-Link Extender has a Troubleshooting guide
- Ensure that the extender is properly connected to the power source and receives sufficient power, and that internet access is stable. Contact your ISP if it isn’t operating properly.
- If your extender isn’t working properly, it could be due to outdated or defective firmware. As a result, you should keep your firmware up to date.
- Restart the extender if necessary. Finally, if all else fails, use the reset option as described above.
Conclusion
If the problem with the blinking light persists even after completing the TP-Link Extender Login process, you can contact our team of specialists by dialing the toll-free number. There is no doubt that they will dispel all of your doubts regarding anything and everything. You can also receive assistance with the TP-Link Extender Setup procedure. For more information, one can also refer to the webpage.
First, RE light of Range Extender is just used to indicate the WPS process. After you press Range Extender’s RE/WPS button, the RE light will start blinking. After several minutes, if RE light becomes solid on, it means WPS process is successful.
