How to setup tp link extender without WPS button?

How to setup tp link extender without WPS button

In this Article we discuss about how to setup TP-Link Extender Setup without WPS button.

 WHAT IS A TP-LINK EXTENDER?

The TP-Link Extender is referred to as a Wi-Fi Extender. It is a device that essentially expands your Wi-Fi signal’s quality and range. These devices are highly utilized in offices, factories, warehouses, etc. to ensure extreme internet speed in all areas.

TP LINK EXTENDER WITHOUT WPS BUTTON
TP-Link Range Extender

TP-Link Extender is needed because it essentially enhances your Wi-Fi association with a similar bandwidth it was before. Which ultimately increases its range and you get solid Wi-Fi association all through the house.

TYPE OF EXTENDERS FROM TP-LINKS

  • Wi-Fi Extender
  • Wi-Fi Repeater

HOW TO SETUP TP-LINK EXTENDER?

Setting up the TP-Link Extender with/without WPS is a really simple process but it does take some time.

Firstly you have to find a place where you want your extender to be.

1. PLACEMENT

Spot your Wi-Fi Extender is very easy. First, take out your house layout and mark a spot you where you need your signal to be. Then, mark the spot where the router is located. Now take your extender and place it halfway between in the middle of both places.

Note: – Try to spot it into an open location for best range.

2. SETUP

Before setting up your TP-Link Extender, you have known a few things.

  • IP Address
  • SSID
  • Password

For setup your TP-Link Extender. Essentially there are two options of doing.

1. SET UP TP-LINK EXTENDER WITHOUT WPS BUTTON

  •  Firstly, plug-in the TP-Link Extender into an electrical outlet and connect it with your PC via Ethernet cable.
  • Then, open your internet browser and visit TPlinkrepeater.net.
  • Select Quick Setup > Region and then click on Next.
  • After this, TP-Link Extender had done scanning your Network select your Wi-Fi network and click next.
  • At last, enter the Password and select copy from main router and click next.

 

 SETUP WITH WPS BUTTON

  • Firstly, plug in the TP-Link Extender in the Electrical outlet nearer to your router.
  • Then, press the WPS button on the back of the router. After the WPS Led starts flickering, press the WPS button on your Extender.
  • Just wait for some time as the TP-Link Extender will automatically configure to your Wi-Fi network.
  • Then check whether the connection is working or not.
Tags: , , , , , ,

Leave a Reply